工作時應注意：新機械或大修后應磨合24小時后方可正常運行。根據地理情況前進后退與提升大臂，動作要靈活，料斗內如有大塊石頭、泥巴等一定要清理。要經常檢查鏈條螺絲、銷子及傳動系統各固定點緊固件一定牢固。磁選船正確調整磁場角度、水的流量，根據用戶要求提取的鐵砂品位，正確調整接鐵砂的角度。
抽沙船使用期間應經常檢查各部位的螺絲并經常加注潤滑油及保養，特別是料斗螺絲及鏈條銷子、水上四角輪與減速機對接盤、水下四角輪等各部螺栓一定緊固完好。
Work should pay attention to: the new machinery or overhaul should run after 24 hours before the normal operation of the rear. Forward and backward according to the geographical situation and enhance the arm, action should be flexible, if there is a large block of stone, mud, etc. must be cleaned up. Always check the chain screws, pins and drive the fasteners must be securely fixed point. Magnetic separation vessel is properly adjust the magnetic field angle, water flow, according to user requirements extracted iron ore grade and correctly adjusting angle iron.
抽沙船使用期間應經常檢查各部位的螺絲并經常加注潤滑油及保養，特別是料斗螺絲及鏈條銷子、水上四角輪與減速機對接盤、水下四角輪等各部螺栓一定緊固完好。
Pumping sand during use should always check the various parts of the screws and often filling lubricating oil and the maintenance, particularly in the hopper screw and chain pin, water under the four corners of the wheel and the reducer butt plate, the water four corners round the bolts must be tightened and intact. |
.jpg)
